How to install the aluminum skirting board?
The aluminum Skirting board is equipped with special internal corner-and-external corner accessories and fixtures.
1, Observe the corner of the ground and the wall if flat. To flatten and clean with a shovel knife or kick-bound up after the uneven and not all against the wall, will leave unsightly cracks.
2, After sawing a section of 15 cm long aluminum skirting board, will be Kaka on the back of the card slot, leaning against the wall in the card buckle hole out to make a mark. Before drilling, we should observe the wiring trend of water and electricity to prevent mistakes.
Drilling interval can not be too large, generally around 40cm more appropriate. Use special tools to drill holes in the wall and then pin the plastic into the holes that have just been drilled.
Fasten the clip to the wall with a screw 3, the wall protruding to the corner is called external corner, concave to the corner called internal corner.
The installation of internal and external corners is the angle of internal and external on the wall to draw a fixed point position, and then take holes, nails plastic, and then the internal and external corner with screws fixed in the corner.
Note: As the pipe of the hydroelectric project is buried on the wall, the switch socket is just below the position of the pipe, the hole should be well positioned to avoid damage. 4, the final use of tape to measure the size of each segment distance, with the cutting machine to cut the corresponding size, card on the corresponding card buckle.
Aluminum skirting board for each length of 3 meters, in excess of the length of the aluminum skirting board in the middle of the interface to install a card fastener, so as to ensure the level of the foot line. Aluminum skirting board to completely close to the wall, do not leave gaps, only more beautiful, especially in the corner.
The flatness of the wall should be tested before installation.